Chevy Truck Backup Lights Not Working. And i dont know where it is located either. I dont have a haynes manual so i cant look it up.
(dd) i had the same problem on my 1990 c1500. If the backup bulbs are good then check the neutral switch as this is where the reverse switch is, its part of the neutral switch. The control module was burnt out due to a fault of my own by splicing in a 35w ballast for an hid kit into my reverse lights.
The issue is the backup lights. When the two wires are bridged together with the key on the reverse lights should work if. I've had another, unrelated fuse blow (but offhand, i don't recall the specific one) because of a wiring problem, and that resulted in the backup lights not working.
Taillights, blinkers, brakelights all work just the backup lights not working The reverse lights became available in 1966 on these models. (dd) i had the same problem on my 1990 c1500.
If you have power out of the switch then check for power and ground at the light socket as there could be a bad wire or connection. If the switch shorts internally, this may cause the lights to stay on permanently. Check all the fuses, both in the underhood fusebox and the one in the drivers end of the dash.
I'm not a mechanic by trade, i can do somethings (brakes, thermostats, hoses, some electrical. Reverse lights do not work on 2005 silverado 1500. I have a th350 so i dont have a semi conductor on the tranny.
(it would probably be cheaper than the original) then use it to turn your bu lights on and. It is the reverse light switch. I've changed the backup light switch even though when i tested the ohm's it checked out fine.
Light Surface Rust On Original Backup Lights.
I Have A 1998 Chevy K1500 With A 305 In It And It's A Manual 5 Speed.
The Brake Lights, Turn Signals, And Back Up Lights Stopped Working.
Anyone Know What I Should Do.
Tried New Tail Light Circuit Board, Stoplight Switch On The.
